3.
Disconnect the stop lamp switch connector (A).
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Remove the lower crash pad.
(Refer to the Body - "Crash Pad")
Disconnect the stop lamp switch connector (A).
Pull the locking plate (A) as indicated by the arrow.
Turn stop lamp switch 45° counterclockwise and remove it.
Fix the brake pedal arm and insert fully the stop lamp switch as hiding contact part.
After inserting, turn the stop switch (A) 45° clockwise, and then assemble locking plate (B) by pushing.
Confirm the gap between stop lamp switch and bracket.
Stop lamp clearance : 1.0 ~ 2.0 mm (0.04~ 0.08 in.)
Connect the stop lamp switch connector.
If the gap between stop lamp switch and bracket is not 1.0 ~ 2.0mm(0.04~ 0.08in), perform the above process again.
Install the lower crash pad.
(Refer to the Body - "Crash Pad")
