3.
Disconnect the EPB control unit connector (A).
Turn ignition OFF and disconnect the negative (-) battery cable.
Remove the front passenger seat assembly.
(Refer to the Body group – “Seat”)
Disconnect the EPB control unit connector (A).
EPB control unit mounting nuts (B) and then remove EPB control unit.
Tighten torque:
7.8 ~ 10.8 N.m (0.8 ~ 1.1 kgf.m, 5.8 ~ 8.0 lb-ft)
Installation is the reverse of removal.
Perform the “Assembly check” with GDS.
Check that the brake operates normally by pushing the EPB switch more than 3 times after installing the EPB module.
