3.
Remove the accelerator pedal assembly from the vehicle after unscrewing the mounting bolt (B) and nuts (C).
Turn ignition switch OFF.
Disconnect the accelerator position sensor connector.
Measure resistance between voltage supply terminal and ground terminal of APS1.
Measure resistance between voltage supply terminal and ground terminal of APS2.
Check that the resistance is within the specification.
Specification: Refer to Specification section.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Disconnect the accelerator pedal position sensor connector (A).
Remove the accelerator pedal assembly from the vehicle after unscrewing the mounting bolt (B) and nuts (C).
Installation is reverse of removal.
Accelerator pedal installation bolt:
8.8 ~ 14.7 N.m (0.9 ~ 1.4kgf.m, 6.5 ~ 10.1 lb-ft)
Accelerator pedal module installation nut:
12.8 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)
When replacing or reinstalling the accelerator pedal, step on the accelerator pedal fully to the end for 1 sec in IG key on position.
Through this procedure, ECM learn full accelator position of the APS.
