3.
Remove the luggage cover board (A).
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Fold the rear seat cushion (Refer to "SEAT" in BD group).
Remove the luggage cover board (A).
Remove the luggage front tray (B).
Remove the service cover (C) after loosening 4 screws.
Disconnect the fuel sender connector (A).
Disconnect the fuel feed tube quick-connector (B) and the fuel return tube quick-connector (C).
Unscrew the fuel sender installation bolts (D), and then remove the fuel sender from the fuel tank.
Installation is reverse of removal.
Fuel sender plate cover installation bolts:
2.0 ~ 2.9 N0m (0.2 ~ 0.3 kgf.m, 1.4 ~ 2.2 lb-ft)
After removing or replacing the part below, bleed air in low pressure fuel circuit (Refer to "BLEEDING AIR IN LOW PRESSURE FUEL CIRCUIT" in this group).
Fuel Tank
Fuel Sender
Fuel Filter
High Pressure Fuel Pump
Low Pressure Fuel Lines
Using an ohmmeter, measure the resistance between terminals 1 and 3 of sender connector (A) at each float level.
Pin No. | discription |
1 | Fuel sender ground |
2 | - |
3 | Fuel sender signal |
4 | - |
Also check that the resistance changes smoothly when the float is moved from "E" to "F".
Position | Resistance (Ω) | Capacity (ℓ) |
E | 198 ~ 205 | 5 |
1/2 | 72.7 | 35 |
F | 7 ~ 9 | 67 |
