Remove the following items;
Engine cover (A).
Air cleaner assembly (B) and air duct (C).
(Refer to "Intake and Exhaust system" in EM group)
Battery and battery tray (D).
(Refer to "Charging system" in EE group)
ECM (E).
(Refer to "Engine Control System" in FL group)
Disconnect the back up lamp switch connector (B) and the speed sensor connector (A).
Disconnect the cable assembly (B) after removing the washer and pin (A).
Remove the ground cable from transaxle (A).
Remove the CKP sensor (A) by removing a bolt.
Disconnect the damper (B) after removing the comcentric slave cylinder clip (A).
Remove the transaxle upper mounting bolts (B-2ea) and the start motor mounting bolts (A-2ea).
Tightening torque:
(A) : 49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)
(B) : 42.2 ~ 54.0 N.m (8.0 ~ 10.0 kgf.m, 31.1 ~ 39.8 lb-ft)
Remove the cowl top cover.
(Refer to "Interior(cowl top cover)" in BD group.)
Using the SST (support SST No. : 09200-2S200, beam SST No. : 09200-38001/3N000 , adapter SST No. : 09200-2S100), hold the engine and transaxle assembly safely.
Remove the cover (A).
Remove the automatic transaxle mounting support bracket bolt (A).
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
Remove the transaxle mounting support bracket bolt (A-3ea).
Tightening torque:
58.8 ~ 78.4 N.m (6.0 ~ 8.0 kgf.m, 43.3 ~ 57.8 lb-ft)
Remove the under cover (A).
Remove the side cover (A).
Remove the roll rod support bracket (C) after removing bolt (A,B).
Tightening torque:
(A) 49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)
(B) 107.9 ~ 127.5 N.m (11 ~ 13 kgf.m, 79.6 ~ 94.1 lb-ft)
Remove the drive shaft assembly.
(Refer to "Drive shaft assembly" in DS group.)
Remove the drive shaft cover (A).
Remove the dust cover by removing the bolts (A-2ea).
Loosen the turbo charger hose by loosening a clamp and removing the bolts (A-2ea).
Remove the lower mounting bolts (A-2ea, B-3ea) of lower part of the transaxle, and the left side cover and remove the transaxle assembly by supporting it with a jack.
Tightening torque:
(A,B) 42.2 ~ 54.0 N.m (4.3 ~ 5.5 kgf.m, 31.1 ~ 39.8 lb-ft)
Be careful not to damage other system or parts near by when removing the engine and transaxle assembly.
Installation is the reverse of removal.
Adding Manual transaxle fluid.
(Refer to "Manual transaxle system" in this group.)
