2.
Remove the duct (A).
Remove the floor Interior console assembly.
(Refer to "Interior(Console)" in BD group)
Remove the duct (A).
Remove the snap pin (B) and remove the select cable assembly (A).
Remove the shift lever assembly (B) by removing the bolts (A-4ea).
Tightening torque:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)
Remove the shift lever assembly (B) by removing the clip (A).
Set securely.
Installation is the reverse of removal.
Remove the floor Interior console assembly.
(Refer to "Interior(Console)" in BD group)
Remove the duct (A).
Remove the snap pin (B) and remove the select cable assembly (A).
Remove the shift lever assembly (B) by removing the bolts (A-4ea).
Tightening torque:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)
Remove the shift lever assembly (B) by removing the clip (A).
Set securely.
Remove the crash pad.
(Refer to "Interior(Crash pad)" in BD group)
Remove the blower Unit.
(Refer to "Blower(Blower Unit)" in HA group)
Remove the retainer (A) and nuts (B-2ea).
Tightening torque:
11.8 ~ 14.7 N.m (1.2 ~ 1.5 kgf.m, 8.7 ~ 10.8 lb-ft)
Remove the pin and washer (A).
Remove the cable (B) from the cable bracket at manual transaxle assembly side.
Remove the shift cable and select cable at cabin room.
Installation is the reverse of removal.
Install the select and shift cable assembly (B) after removing the pin (A).
Install is the shift cable (A).
At this time, have to disconnect select cable.
Install the shift lever assembly (B) by removing the bolts (A-4ea).
Tightening torque:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)
Shift to the 3th gear position.
Insert the selected cable (A) to the shift lever assembly pin (B).
You have to push in the adjuster (C).
Remove the neutral position pin (D).
Install the snap pin (E).
