1.
Using a screwdriver or remover, remove the gear boots (A).
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.
Using a screwdriver or remover, remove the gear boots (A).
Using a screwdriver or remover, remove the console upper cover (A).
Disconnect the connector (A).
Using a scerwdriver or remover, remove the console front tray (A).
Disconnect the connectors (A).
Remove the armrest tray assembly (A).
Remove the armrest met (A).
Using a scerwdriver or remover, remove the console extension cover (A).
[LH]
[RH]
After loosening the mounting screws and bolts, then remove the floor console assembly (A).
Disconnect the floor console main connectors (A).
[Rear]
[Front]
Install in the reverse order of removal.
Make sure the connector are connected in properly.
Replace any damage clips.
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.
Using a screwdriver or remover, remove the gear boots (B) and gear knob (A).
Using a screwdriver or remover, remove the console upper cover (A).
Disconnect the connectors (A).
Using a screwdriver or remover, remove the console front tray (A).
Disconnect the connector (A).
Remove the armrest tray assembly (A).
Remove the armrest met (A).
Using a screwdriver or remover, remove the console extension cover (A).
[LH]
[RH]
After loosening the mounting screws and bolts, then remove the floor console assembly (A).
Disconnect the floor console main connectors (A).
[Rear]
[Front]
Install in the reverse order of removal.
Make sure the connectors are connected in properly.
Replace any damage clips.
When prying with a flat-tip screwdriver, wrap itwith protective tape, and apply protective tapearound the related parts, to prevent damaged
Put on gloves to protect your hands.
Take care not to scratch the body surface.
After loosening the mounting screws, then remove the rear console cover (A).
Disconnect the connector (A).
Install in the reverse order of removal.
Make sure the connector is connected properly.
Replace any damaged clips.
When prying with a flat-tip screwdriver, wrap itwith protective tape, and apply protective tapearound the related parts, to prevent damaged
Put on gloves to protect your hands.
Take care not to scratch the body surface.
Using a screwdriver or remover, remove the armrest cover (A).
After loosening the mounting screws, then remove the armrest assembly (A).
Install in the reverse order of removal.
Replace any damaged clips.
