2.
Disconnect the rear bumper main connector (A).
Put on gloves to protect your hands.
Use a plastic panel removal tool to remove interior trim pieces to without marring the surface.
Take care not bend or scratch the cover and other parts.
Remove the following items.
Rear seat assembly
(Refer to the BD group - "Rear Seat")
Rear seat side back assembly
(Refer to the BD group - "Rear Seat")
Rear door scuff trim
(Refer to the BD group - "Interior Trim")
Cargo screen
(Refer to the BD group - "Interior Trim")
Barrier net
(Refer to the BD group - "Interior Trim")
Rear transverse trim
(Refer to the BD group - "Interior Trim")
Luggage side trim
(Refer to the BD group - "Interior Trim")
Disconnect the rear bumper main connector (A).
After loosening the mounting screws, then remove the rear combination lamp (A).
Remove the turn signal lamp(A) by turning the sockets counterclockwise.
Disconnect the stop lamp connector (B).
After loosening the rear bumper side's mounting screws, then disconnect the side's.
Loosen the rear bumper lower mounting clips.
Loosen the rear bumper lower mounting bolts.
Loosen the rear bumper upper mounting screw and clip.
Remove the rear bumper cover (A).
Install in the reverse order of removal.
Make sure the connector is plugged in properly.
Replace any damaged clips.
Put on gloves to protect your hands.
Use a plastic panel removal tool to remove interior trim pieces to without marring the surface.
Take care not bend or scratch the cover and other parts.
Remove the rear transverse trim.
(Refer to the BD group - "Trunk Trim")
Remove the luggage side trim [LH, RH]
(Refer to the BD group - "Trunk Trim")
Disconnect the rear combination lamp connector (A).
After loosening the mounting screws, then remove the rear combination lamp (A).
After loosening the rear bumper side’s mounting screws and clip, then disconnect the side’s.
Disconnect the main muffler (A) from the hanger (B).
Loosen the rear bumper lower mounting bolts.
Loosen the rear bumper side mounting screw and clips.
Push the lock pin, disconnect the rear bumper main connector (A).
Remove the rear bumper cover (A).
Install in the reverse order of removal.
Make sure the connector is plugged in properly.
Replace any damaged clips.
