ENGINE STALLING INTERMITTENTLY
Inspection procedure
1.

Check poor conection of the ignition S/W power supply circuit.

2.

Measure the voltage between "ON/START power" terminal of "ECM/PCM" harness connector and chassis ground.

■ Specification

IG key "ON" : 11.5V~13.0V

IG key "OFF" : Below 0.2V

3.

Is the measured voltage value normal?

▶ Check power supply and operating state of the engine control relay.

▶ Repair open between "ON" terminal of the ignition S/W and "ON/START power" terminal of "ECM/PCM" harness connector.

▶ Go to "ECM/PCM" inspection procedure.

Яндекс.Метрика