3.
Place a passenger airbag on the crash pad and tighten the passenger airbag mounting bolts (A).
Tightening torque:
6.0 ~ 8.0 N.m (0.6 ~ 0.8 kgf.m, 4.4 ~ 5.9 lb-ft)
Remove the ignition key from the vehicle.
Disconnect the battery negative cable from battery and wait for at least three minutes before beginning work.
Place a passenger airbag on the crash pad and tighten the passenger airbag mounting bolts (A).
Tightening torque:
6.0 ~ 8.0 N.m (0.6 ~ 0.8 kgf.m, 4.4 ~ 5.9 lb-ft)
Install the crash pad.
(Refer to Body - "Crash Pad")
Tighten the passenger airbag mounting bolts.
Tightening torque :
9.0 ~ 14.0 N.m (0.9 ~ 1.4 kgf.m, 6.6 ~ 10.3 lb-ft)
Connect the passenger airbag harness connector to the SRS main harness connector.
Reinstall the glove box.
(Refer to Body - "Crash Pad")
Reconnect the battery negative cable.
After installing the passenger airbag (PAB), confirm proper system operation :
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
