Remove the ignition key from the vehicle.
Disconnect the battery negative cable and wait for at least three minutes.
Tighten the curtain airbag mounting bolts.
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Never twist the airbag module when installing it. If the module is twisted, airbag module may operate abnormally.
Connect the curtain airbag connector.
Install the roof trim.
(Refer to Body - "Interior")
Reconnect the battery negative cable.
After installing the curtain airbag (CAB), confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
