2.
Remove the drive belt.
(1)
Loosen the through bolt (A).
(2)
Loosen the tension by turning the tension adjusting bolt (B).
(3)
Remove the drive belt (A).
Disconnect the battery negative terminal first, then the positive terminal.
Tightening torque :
(+) terminal :
7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2lb-ft)
(-) terminal (without battery sensor):
7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2lb-ft)
(-) terminal (with battery sensor):
3.9 ~ 5.9N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft)
Remove the drive belt.
Loosen the through bolt (A).
Loosen the tension by turning the tension adjusting bolt (B).
Remove the drive belt (A).
Disconnect the A/C compressor switch connector (A), the alternator connector (B) and the cable from the alternator "B" terminal (C).
Remove the alternator (A).
Tightening torque :
19.6~26.5 Nm (2.0~2.7 kgf.m, 14.5~19.5 Ib-ft)-12mm bolt
29.4~41.2 Nm (3.0~4.2 kgf.m, 21.7~30.4 Ib-ft)-14mm bolt
Installation is the reverse order of removal.
Adjust the alternator belt tension after installation.
