3.
Using the SST (09495-3K000), secure the boot band.
Clearance (A): 2.0 mm (0.079 in) or less
Wrap tape around the driveshaft spline(TJ) to prevent damage to the boots.
Apply grease to the joint boot on the side of the wheel and install the boot.
Using the SST (09495-3K000), secure the boot band.
Clearance (A): 2.0 mm (0.079 in) or less
To install the dynamic damper (A), keep the shaft in a straight line and assemble the dynamic damper with the bands(B).
Assemble the transaxle side joint boot and bands.
Using the alignment marks (D) made during disassembly as a guide, install the spider assembly (A) and snap ring (B) on the driveshaft splines (C).
Add specified grease to the joint boot as much as it was wiped away at inspection.
Install the both boot band.
To control the air in the TJ boot, keep the specified distance between the boot band when they are tightend.
Engine& T/M | Distance(L) mm(in) | |
LH side | RH side | |
Gamma 1.6 GDI 6M/T | 551.6 (21.7) | 836.6 (32.9) |
U-II 1.7 High 6A/T | 532.7 (21.0) | 820.7 (32.3) |
U-II 1.7 High 6M/T | 532.7 (21.0) | 855.9 (33.7) |
U-II 1.7 Low 6M/T | 539.6 (21.2) | 851.0 (33.5) |
Nu 2.0 MPI/GDI 6A/T | 531.5 (20.9) | 821.7 (32.3) |
Nu 2.0 MPI/GDI 6M/T | 538.4 (21.2) | 850.8 (33.5) |
Using the SST (09495-3K000), secure the TJ boot bands.
