Do not use already used injector fixing clip again.
Do not reuse the support disc.
Do not reuse the injector rubber washer.
Do not reuse the combustion seal.
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Apply engine oil to the injector O-ring.
Do not use already used injector O-ring again.
Do not use already used bolt again.
When insert the injector, be careful not to damage the injector tip.
Install in the reverse order of removal.
Delivery pipe installation bolt:
18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)
High pressure fuel pipe installation nut:
26.5 ~ 32.4 N.m (2.7 ~ 3.3 kgf.m, 19.5 ~ 23.9 lb-ft)
