4.
Disconnect the airbag module connector (A) & horn connector (B) and then remove the airbag module from the steering wheel.
Disconnect the battery negative cable from the battery and then wait for at least 30 seconds.
Turn the steering wheel so that the front wheels can face straight ahead.
Separate the airbag module from the steering wheel.(Refer to RT group - "Air bag Module")
Disconnect the airbag module connector (A) & horn connector (B) and then remove the airbag module from the steering wheel.
Disconnect the connector & lock nut (A) and then remove the steering wheel by using special service tools (09561-11001).
Tightening torque:
39.2 ~ 44.1N.m (4.0 ~ 4.5 kgf.m, 28.9 ~ 32.5lb-ft)
Do not hammer on the steering wheel to remove it; it may damage the steering column.
Installation is the reverse of the removal.
Loosen the screw and then remove the lower cover (A) from the steering wheel body.
Disconnect the heated steering wheel unit connector and then remove the heated steering wheel unit (A).
Remove the wiring (A).
Remove the remote control switch assembly (A).
Installation is the reverse of the removal.
Check the strain of steering wheel body.
Check the status of the wire to short and open circuit.
Check that remote control to operate normally when installing.
