2.
Disconnect the camshaft position sensor connector (A).
Check signal waveform of CMPS and CKPS using a scan tool.
Specification: Refer ro "Signal Waveform"
DON’T remove the camshaft position sensor during engine running or right after engine stops, or a scald by the flowed out engine oil may occur.
Turn the ignition switch OFF and disconnect the battery (-) cable.
Disconnect the camshaft position sensor connector (A).
Remove the camshaft position sensor.
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Apply the engine coolant to the O-ring.
Be careful not to damage the O-ring.
Insert the sensor in the installation hole and be careful not to damage when installation.
Be careful not to damage the sensor housing and the connector.
Installation is reverse of removal.
Camshaft position sensor installation bolt:
7.8 ~ 9.8 N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2 lb-ft)
