3.
Remove the smart key unit (A) after disconnecting the connector and loosening the mounting nuts (2EA).
Take care not to scratch the crash pad and related parts
Disconnect the negative (-) battery terminal.
Remove the glove box.
(Refer to Body - "Crash Pad")
Remove the smart key unit (A) after disconnecting the connector and loosening the mounting nuts (2EA).
Take care not to scratch the crash pad and related parts
Disconnect the negative (-) battery terminal.
Remove the glove box.
(Refer to Body - "Crash Pad")
Remove the RF receiver (A) after loosening the mounting nuts (2EA) and disconnecting the connector.
Disconnect the negative (-) battery terminal.
Remove the floor console tray (A) after loosening the mounting screws.
(Refer to Body - "Console")
Remove the interior 1 antenna (A) after disconnecting the connector and loosening the mounting screws (2EA).
Disconnect the negative (-) battery terminal.
Remove the center console rear cover (A).
(Refer to Body - "Console")
Disconnect the interior 2 antenna connector located at the console rear side, then remove the interior 2 antenna (A) after loosening screws (2EA).
Disconnect the negative (-) battery terminal.
Remove the trunk transverse trim.
(Refer to Body - "Interrior Trim")
Disconnect the trunk antenna connector (A) and remove the trunk antenna (B) after loosening nut (2EA).
Disconnect the negative (-) battery terminal.
Remove the rear bumper.
(Refer to Body - "Rear Bumper")
Disconnect the antenna connector (B) and remove the exterior bumper antenna (A) after loosening the screws (2EA).
Disconnect the negative (-) battery terminal.
Remove the left side wheel guard.
(Refer to Body - "Front Bumper")
Remove the external buzzer (A) after disconnecting the connector.
Disconnect the negative (-) battery terminal.
Disconnect the connector after removing the door trim.
(Refer to Body - "Front Door")
Remove the outside handle (A) by sliding it rearward.
(Refer to Body - "Front Door")
Disconnect the door outside handle connector (A).
Disconnect the negative (-) battery terminal.
Remove the trunk door trim.
(Refer to Body - "Trunk")
Remove the trunk lid panel after disconnecting the connector and loosening the mounting screws.
(Refer to Body - "Trunk Lid")
Disconnect the trunk lid open switch connector (A).
Remove the outside handle (A) from the trunk garnish after loosening the trunk outside handle mounting screws.
