10613255-10613253-10613267-10613269-10613271-10613251-10613259

Component Location

General Description

RPS(Rail Pressure Sensor), consists of piezzo electric element, measures rail pressure inside of common rail.

ECM determines optimum fuel injection quantity at specific engine condition based on RPS signal. RPS signal is also used as rail pressure regualtor feed back signal in order to achieve optimum rail pressure at certain engine condition.

1. Connector

2. Measurement circuit

3. Sensor element(diaphragm)

4. Rail pressure

5. Fuel rail

DTC Description

P0192 is set when RPS output voltage is below the minimum value of 254mV for more than 0.2 sec.. This code is due to the open in power circuit or the short to ground in signal circuit.

DTC Detecting Condition

Item	Detecting Condition			Possible Cause
DTC Strategy	• Voltage monitoring			• RPS circuit • RPS component
Enable Conditions	• Engine running
Threshold Value	• Output sinal below minimum value (below 189mV)
Diagnostic Time	• 200ms
Fail Safe	Fuel cut	NO	• Rail press. Sensor value fixed at 330bar
	EGR Off	NO
	Fuel Limit	YES
	Check Lamp	YES

Specification

Diagnostic Circuit Diagram

Signal Waveform

Fig 1) This waveform shows the rise of RPS output voltage at rapid acceleration.