If clutch switch signal is not detected while gear shift is detected, ECM sets DTC P083000. This fault might be caused by open or short to power/ground in circuit of clutch switch.
Item | Detecting Condition | Possible Cause | |
DTC Strategy |
•
Signal monitoring | 1. Open or short to power/ground in signal circuit of clutch gear switch 2. Defected clutch gear switch | |
Enable Conditions |
•
Driving condition
•
Engine speed higher than 1,500RPM | ||
Threshold Value |
•
Clutch switch signal is not detected for 20 sec
•
Clutch switch position signal is not changed while vehicle speed is increased to 80km/h(50mph) | ||
Fail Safe | Engine OFF |
•
No | |
EGR Off |
•
No | ||
Torque Limit |
•
No | ||
MIL |
•
Off | ||
