Ignition switch "OFF"
Disconnect battery (-) cable.
Refer to "Shop Manual" and remove EOPS.
Measure the resistance between signal terminal of EOPS and EOPS body ground.(A)
Measure the resistance between signal terminal of EOPS and EOPS body ground while pressing oil hole with thin stick.(B)
Specification :(A) : Continuity measured / (B) : No continuity measured
Fig.1) (A) Inspection Method
Fig.2) (B) Inspection Method
Is the measured value within specification?
 | ▶ Fault is intermittent caused by poor contact in the sensor's and/or ECM's connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of vehicle Repair" procedure. |
 | ▶ Carefully re-do this troubleshooting guide steps. ▶ If no problems were found with the circuits or connectors, replace the EOPS and go to "Verification of Vehicle Repair" procedure. |
When installing component, tighten it within specification
If component is dropped, check for proper operation. The internal damage may be present
