Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.

Thoroughly check all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.

Has a problem been found?

	▶ Repair as necessary and then go to "Verification of Vehicle Repair" procedure.
	▶ Go to "Signal Circuit Inspection" procedure.

Ignition switch "OFF"

Refer to "Shop Manual" and disconnect EOPS connector.

Ignition switch "ON"

Measure the voltage between oil pressure switch terminal of EOPS harness connector and chassis ground.

Is the measured value within specification?

	▶ Go to "Component Inspection" procedure.
	▶ Inspect and repair open or short in circuit, and then go to "Verification of Vehicle Repair" procedure.