Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.

Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

Has a problem been found?

	▶Repair as necessary and go to "Verification vehicle Repair" procedure.
	▶ Go to "Power circuit inspection" procedure.

Ignition "ON" & Engine "ON" and Operate "Select Solenoid 2".

Connect the "Select Solenoid 2" connector.

Measure Voltage between "Solenoid Push/Pull" terminal of the Shift Solenoid2 harness connector and chassis ground.

Is resistance within specifications ?

	▶ Substitute with a known-good "Selecth Actuator" and check for proper operation. If the problem is corrected, replace "Select Actuator" as necessary and then go to "Verification of Vehicle Repair" procedure.
	▶ Check for open or short in harness. Repair as necessary and Go to "Verification Vehicle Repair" procedure.