3.
Has a problem been found?
 | ▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure. |
 | ▶ Go to "Ground Circuit Inspection" procedure. |
Many malfunctions in the electrical system are caused by poor harness(es) and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
Has a problem been found?
| ▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure. |
| ▶ Go to "Ground Circuit Inspection" procedure. |
Ignition Switch "OFF"
Disconnect battery (-) cable.
Refer to "Shop Manual" and disconnect the FTS connector.
Measure the resistance between ground terminal of FTS harness connector and chassis ground.
Specification :Approx. below 1Ω
Ignition switch "OFF"
Refer to "Shop Manual" and disconnect the FTS connector.
Ignition switch "ON"
Measure the voltage between signal terminal of FTS harness connector and chassis ground.(A)
Measure the voltage between signal terminal and ground terminal of FTS harness connector.(B)
Specification :Difference (A) and (B) is less then 200 mV
Is the measured value within specification?
| ▶ Go to "Signal Circuit Inspection" procedure. |
| ▶ Inspect and repair open or short in circuit, and then go to "Verification of Vehicle Repair" procedure. |
Ignition switch "OFF"
Refer to "Shop Manual" and disconnect the FTS connector.
Ignition Switch "ON"
Measure the voltage between signal terminal of FTS harness connector and chassis ground.
Specification :Approx. 5.0V
Is the measured value within specification?
| ▶ Go to "Component Inspection" procedure. |
| ▶ Inspect and repair open or short in circuit, and then go to "Verification of Vehicle Repair" procedure. |
