4.
Move selector lever from "P" range to "D" range. And Driving the vehicle shifting from 1st gear to 7th gear.
Fig.1) 1st ~ 2nd gear
Fig.2) 2nd ~ 3rd gear
Fig.3) 3rd ~ 4th gear
Fig.4) 4th ~ 5th gear
Fig.5) 5th ~ 6th gear
Fig.6) 6th ~ 7th gear
Connect GDS to data link connector(DLC).
Engine "ON"
Monitor the "Shift Motor 2 Position, Shift Motor 2 Current, Select 2 Position Sensor, Current Gear" parameter on the "Current Data" with GDS and select Graph mode.
Move selector lever from "P" range to "D" range. And Driving the vehicle shifting from 1st gear to 7th gear.
Fig.1) 1st ~ 2nd gear
Fig.2) 2nd ~ 3rd gear
Fig.3) 3rd ~ 4th gear
Fig.4) 4th ~ 5th gear
Fig.5) 5th ~ 6th gear
Fig.6) 6th ~ 7th gear
Does "Current data" follow the referance data?
 | ▶ Fault is intermittent caused by poor contact in the sensor's and/or TCM(PCM)'s connector or was repaired and TCM(PCM) memory was not cleared. Throughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage.Repair or replace as necessary and go to "Verification Vehicle Repair" procedure. |
 | ▶ Go to "W/Harness Inspection" procedure. |
