3.
Disconnect the solenoid valve connector (A).
Turn ignition switch OFF.
Remove the battery and battery tray.
Disconnect the solenoid valve connector (A).
Measure resistance between sensor signal terminal and sensor ground terminal.
Check that the resistance is within the specification.
If DTC about the input/output speed sensor is found, replace according to the procedures removal/installation.
Remove the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
Disconnect the input & output speed sensor connector (A).
Loosen the main connctor bolt (B).
Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Disconnect the solenoid valve connector (A).
Press the lock
Pull up lever
Remove the solenoid valve connector mounting clip (A).
Remove the solenoid valve connector (A) by pushing down from the transaxle.
Replace the O-Ring (A) before reinstalling solenoid valve connector.
Install in the reverse order of removal.
Perform the procedures below after replacing the oil temperature sensor.
Refill the engine with coolant.
(Refer to Cooling System - "Coolant")
Check fluid level after filling the automatic transaxle with fluid.
(Refer to Hydraulic System - "Fluid")
