Components | Location reference-page | ||
C02 | Water temperature sensor & Gauge | ||
C03 | Knock sensor | ||
C05 | Crankshaft position sensor | ||
C09 | Transaxle range switch | ||
C12 | Vehicle speed sensor | ||
C23 | Variable resistor | ||
C25 | Oxygen snesor (B2/S1) | ||
C26 | Oxygen sensor (B1/S1) | ||
C27-1 | Variable intake sensor | ||
C27-2 | Variable intake motor | ||
C28-1 | Injector #1 | ||
C28-2 | Injector #2 | ||
C28-3 | Injector #3 | ||
C28-4 | Injector #4 | ||
C28-5 | Injector #5 | ||
C28-6 | Injector #6 | ||
C29 | Camshaft position sensor | ||
C31 | Purge control solenoid valve | ||
C33 | EGR solenoid | ||
C41 | Joint connector | ||
C42 | Joint connector | ||
C44-1 | E/TCM | ||
C44-2 | E/TCM | ||
C44-3 | E/TCM | ||
C44-4 | E/TCM | ||
C46 | Engine control relay | ||
C48 | A/T control relay | ||
C50 | Ignition failure sensor | ||
C51 | Ignition coil #1 | ||
C52 | Ignition coil #2 | ||
C53 | Ignition coil #3 | ||
C54 | Power steering switch | ||
C55 | Oxygen sensor (B2/S2) (EOBD) | ||
C56 | Oxygen sensor (B1/S2) (EOBD) | ||
I18-1 | Instrument cluster | ||
I18-2 | Instrument cluster | ||
I21 | Trip computer | ||
M03 | Ignition switch | ||
M04 | Multipurpose check connector | ||
M05 | Data link connector | ||
M12 | EPS control module | ||
M33-3 | ETACM | ||
M62 | Fuel sender & Fuel pump motor | ||
Connectors | |||
CC01 | |||
CC02 | |||
JC01 | |||
I/P-G | |||
I/P-H | |||
I/P-P | |||
JM09 | |||
MC01 | |||
MC02 | |||
MC03 | |||
MI02 | |||
MM02 | |||
Grounds | |||
G07 | |||
G13 | |||
G14 | |||
G16 | |||
Circuit Description | |
The Multiport Fuel Injection (MFI) control system is an electronic fuel metering system with fuel injectors near the inlet port of each cylinder. The amount of fuel injection is determined by the ECM according to enginespeed and intake air-flow quantity measured. | The emission control system includes the oxygen sensor and catalytic converters. The MFI's three major functions are air-fuel mixture control, idle speed control, and ignition timing control. mode switch signal. |
