1.
Using ID key
Disconnect the negative (-) battery terminal.
Remove the center facia panel using a screwdriver and disconnect the switch connectors.
Unscrew the audio mounting screws and remove the audio assembly from the mounting bracket.
Remove the flange nuts holding the ICM(Immobilizer Control Module) from left hand center facia support bracket.
INITIAL PASSWORD
The initial password for ICM has been set by the manufacturer as 2345.
Key can be registered and corrected by using the initial password until a new password is registered.
PASSWORD REGISTRATION AND CHANGE
Using a tester(Hi-scan), the initial password(preset as 2345 all) can be replaced by a new password nominated by the owner.
4 numbers among 0-9 can be registered as password.
Once the password has been changed from 2345, the ICM is ready to record the ID code.
Using ID key
Using password
When the customers lost the ID key, new master keys can be registered by using Hi-scan only.
ID key can not be corrected and reproduced.
Once the password is mis-registered, it is impossible to register new password during 10 seconds regardless of ignition ON/OFF.
When the new master keys have been registered, the codes for existing master keys are all cleared.
The password should consist of 4 numbers among ten (0-9) numbers.
