1.
Install the oil pump case with the gasket.
Tightening torque |
Oil pump case bolt : |
12-15 Nm (120-150 kg.cm, 9-11 lb.ft) |
Oil pump cover screw : |
8-12 Nm (80-120 kg.cm, 6-9 lb.ft) |
Install the oil pump case with the gasket.
Tightening torque |
Oil pump case bolt : |
12-15 Nm (120-150 kg.cm, 9-11 lb.ft) |
Oil pump cover screw : |
8-12 Nm (80-120 kg.cm, 6-9 lb.ft) |
Install the oil seal into the oil pump case as tightly as possible, using the special tool (09214-33000).
Install the relief plunger and spring, and tighten the oil relief valve plug to the specified torque.
Tightening torque |
Oil relief valve plug : |
40-50 Nm (400-500 kg.cm, 29-36 lb.ft) |
Install the oil screen and a new gasket.
Tightening torque |
Oil screen bolt : |
15-22 Nm (150-220 kg.cm, 11-15 lb.ft) |
Clean the gasket surfaces of the cylinder block and the oil pan.
Apply sealant to the groove of the oil pan flange.
Make the first cut approx. 4 mm from the end of the nozzle furnished with the sealant. After application of the sealant, do not exceed 15 minutesbefore installing the oil pan.
Make sure that the sealant doesn't enter the inside of the oil pan.
Install the oil pan and tighten the bolts to the specified torque.
Tightening torque |
Oil pan bolt : |
* : 19-28 Nm (190-280 kg.cm, 14-20 lb.ft) |
** : 5-7 Nm (50-70 kg.cm, 4-5 lb.ft) |
*** : 30-42 Nm (300-420 kg.cm, 22-30 lb.ft) |
Tighten the oil pan bolts as shown in the illustration.
Using a 24 mm deep socket, install the oil pressure switch after applying sealant to the threaded area.
Sealant : Three bond No.1104E or equivalent |
Do not torque the oil pressure switch too much.
Tightening torque |
Oil pressure switch : |
8 - 12 Nm (80 - 120 kg.cm, 6 - 9 lb.ft) |
Tighten the lower oil pan bolts as shown in figure.
