4.
Position the washer so that the convex side faces outside and install the castle nut and split pin.
Apply gear oil on the driveshaft splines and differential case contacting surface.
Before installing the driveshaft, set the opening side of the circlip so that it faces downward.
Replace the circlip with new ones after removal.
After installation, check that the driveshaft cannot be removed by hand.
Position the washer so that the convex side faces outside and install the castle nut and split pin.
Replace the self-locking nuts and split pin with new ones after removal.
Tighten the following parts to the specified torque.
Driveshaft castle nut : 200~280 (2000~2800, 148~207) |
Lower arm ball joint to knuckle : 100~120 (1000~1200, 74~88) |
