2.
Install the pads onto each pad clip.
note
All four pads must be replaced as a complete set.
When replacing the brake pad, check for deformation and then replace the guide spring with a new one or use it again after removing foreign material.
Install the pad clips.
Install the pads onto each pad clip.
All four pads must be replaced as a complete set.
When replacing the brake pad, check for deformation and then replace the guide spring with a new one or use it again after removing foreign material.
Press in the piston with a hammer handle or equivalent.
Lower and insert the brake cylinder carefully so as not to damage the boot.
Install the two guide rod bolts and tighten.
Tighten the connections to the specified torque.
Guide rod bolt : |
22-32 Nm (220-320 kg·cm, 16-24 lb·ft) |
Install the pads and brake cylinder.
Install the brake hose to the caliper.
Bleeder screw tightening torque : |
7-9 Nm (70-90 kg·cm, 5-7 lb·ft) |
Fill the brake reservoir with brake fluid.
Bleed the system.
