1.
Remove the windshield wiper arm and blade.
note
Care must be taken not to scratch the engine hood.
Remove the windshield wiper arm and blade.
Care must be taken not to scratch the engine hood.
Remove the weather strip and the cowl top cover.
Disconnect the windshield wiper motor connector and remove the windshield wiper motor and link.
Tightening torque 7-11Nm (70-110kg.cm, 5.1-8.0lb.ft) |
Install the wiper arm to the specified position.
Specified position | A | B |
Distance (mm) | 35 ± 5 | 35 ± 5 |
Set the washer nozzle on the specified spray position.
Remove the connector from the wiper motor.
Attach the positive (+) lead from the battery to terminal 4 and the negative (-) lead to terminal 1.
Check that the motor operates at low speed.
Connect the positive (+) lead from the battery to terminal 4 and the negative (-) lead to terminal 2.
Check that the motor operates at high speed.
Operate the motor at low speed.
Stop the motor operation anywhere except at the off position by disconnecting terminal 5.
Connect terminals 1 and 5.
Connect the positive (+) lead from the battery to terminal 4 and the negative (-) lead to terminal 3.
Check that the motor stops running at the off position.
With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
Connect positive (+) and negative (-) battery cables to terminals 1 and 2 respectively to see that the washer motor runs and water sprays fromthe nozzles.
