1.
Install idler pulley to engine support lower bracket.
The methed of installing timing belt and auto tensioner.
Install idler pulley to engine support lower bracket.
Install tensioner arm, shaft and plane washer to cylinder block.
: 35 - 55 Nm (350 - 550 kg.cm) |
Install crankshaft sprocket and align the timing mark.
Be careful not to bend crankshaft sensing blade.
Install camshaft sprocket and adjust initial installation state as illustration.
Install auto tensioner to oil pump case.
At this time auto tensioner's set pin should be assembled completely.
Aligh the timing marks of each sprocket and install the timing belt in this order.
Crankshaft sprocket → Idler pulley → Exhaust camshaft sprocket (LH) → Intake camshaft sprocket (LH) → Water pump pulley → Intake camshaft sprocket (RH) → Exhauft camshaft sprocket (RH) →Tensioner pulley
In this step, No. 1 is in TDC (Compression stroke)
Do not insert fingers.
After installating the timing belt, recontirm the timing mark.
Install the tensioner pulley.
Pull out the auto tensioner set pin after adjusting timing belt tension. (Refer to "How to adjust timing belt tension")
Tension setting (While auto tensioner is not operating : And fixing pin being kept installed.).
After rotating crankshaft 1/4 revolution reversely, rotate it clockwise to position No. 1 cylinder at TDC.
Then, loosen the center bolt and give the belt 50kg-cm of tension with tensioner pulley socket (Two pins are attached) and torque wrench. While maintaining this state, tighten the center bolt to the standard torque.
Center bolt standard torque :
43 - 55 Nㆍm (430 - 550kgㆍcm, 31.72 - 40.57 lbㆍft)
Pull out the auto tensioner fixing pin.
How to check tension (While auto tensioner is operating : and fixing pin being uninstalled.)
After rotating crankshaft 2 revolutions clockwise to position No. 1 cylinder at TDC, wait for about 5minutes, and measure the amount of protruding of the auto tensioner rod.
This is "leak down" time for the auto tensioner rod to protrude 1mm when tension caused by rotation of the crankshaft has changed.
Check if the amount of rod protruding is in the range of 3.8~4.5mm (0.15~0.18in.).
Recheck if each sprocket is within the specified range.
If it is not within the specified range, repeat from procedure 6 as service procedure of timing belt and auto tensioner installation method.
