Remove the clutch hub retaining bolt with the aid of a spanner wrench.

Pull the clutch hub. If the hub can not be pulled from the compressor shaft, screw an 8 mm bolt into the shaft hole of the clutch hub to force thehub from the shaft.

Remove the pulley retaining snap ring and then pull the pulley and bearing assembly from the compressor.

Remove the clutch hub and pulley following the procedure given.

Install shaft protector tool on the nose opening of the compressor.

Install the pulley on the compressor as shown in the illustration. Place the tip of the puller screw on the center dimple of the shaft protector andthe jaws of the puller around the back side of the field coil.

Tighten the forcing screw with a wrench to pull the coil loose from the compressor front head.