1.
Connect a HI-SCAN (PRO) to the data link connector.
note
Before inspecting the TPS, verify the basic idle speed is as specified.
Connect a HI-SCAN (PRO) to the data link connector.
Before inspecting the TPS, verify the basic idle speed is as specified.
If a HI-SCAN (PRO) is not used, connect a digital type voltmeter between ground and TPS output terminal.
Standard value (ETS vehicle) : 300~900mV |
Turning the TP Sensor clockwise increases the output voltage.
Tighten the screws securely after adjustment.
Turn the ignition switch to the OFF position.
