1.
Disconnect the terminal(A) from the battery(B).
Use fender covers to avoid damaging painted surfaces.
To avoid damage, unplug the wiring connectors carefully while holding the connector portion.
Mark all wiring and hoses to avoid misconnection.
Inspection the timing belt before removing the cylinder head.
Turn the crankshaft pulley so that the No. 1 piston is at top dead center.
Disconnect the terminal(A) from the battery(B).
Remove A engine cover.
Remove the front bumper upper cover (A) and the air duct (B).
Remove the radiator cap to speed daring.
Loosen the radiator drain plug (A) and drain engine coolant.
Remove the air cleaner assembly.
Disconnect the power train module (PCM) connector (A).
Disconnect the intake hose (B).
Remove the air cleaner assembly (C).
Remove the battery tray (A) and the front connector (B).
Remove the upper radiator hose (A) and lower radiator hose (B).
Disconnect the auto transaxle fluid (ATF) hose (A).
Remove the heater hose (A).
Remove the junction box cover.
Remove the engine wire harness connectors(A) and wire harness clamps from the engine room fuse and relay junction box.
Remove the el inlet from delivery pipe (A) and brake booster vacuum hose (B).
Disconnect the accelerator cable (C) and the auto-cruise cable(D) from the cylinder head cover.
Remove the transaxle wire and control cable. (Refer to Transaxle control system in MTA or ATA Group).
Remove the high ＆ low pressure pipe. (Refer to Air conditioner compressor in HA Group).
Remove the steering u-joint mounting bolt(A).
Install the SST (09200-38001, 09200-1C000), the engine support fixture and the adapter, on the engine and transaxle assembly.
Remove the engine mounting bracket (A) by removing the bolt(B) and nuts(C, D) and ground line (F).
Remove the transaxle mounting bracket (A) and the ground line (B).
Remove the front tires.
Disconnect the stabilizer bar link and remove the mounting bolts from the lower arm and the front axles.
Remove the front muffler (A) and disconnect the rear oxygen sensor connector(B).
Remove the sub frame bolts (A).
Remove the engine support fixture and the adapter.
Jack up the vehicle.
Perform the following :
Adjust shift cable.
Adjust throttle cable.
Refill engine with engine oil.
Refill transaxle with fluid.
Refill radiator with engine coolant.
Bleed air from the cooling system with the heater valve open.
Clean battery posts and cable terminals with sandpaper assemble them, then apply grease to prevent corrosion.
Inspect for fuel leakage.
After assembling the fuel line, turn on the ignition switch (do not operate the starter) so that the fuel pump runs for approximately two seconds and fuel line pressureizes.
Repeat this operation two or three times, then check for fuel leakage at any point in the fuel line.
