4.
Using a scantool, clear the DTC.
Side Impact Sensor(SIS) is located in both side of center pillar detects broad collision.
When SIS delivers collision signal to SRSCM, SRSCM checks if safing sensor located in SRSCM detects collusion.
And if both SIS and safing sensor detects collision simultaneously, SRSCM operates side air bag and curtain air bag.
The SRSCM sets DTC B1400/B1403 if there is any fault in DSIS/PSIS circuit.
The SRSCM sets DTC B1409/B1410 if there is any error in communication between DSIS/PSIS and SRSCM.
Item | Detecting Condition | Possible cause | |
DTC Strategy | ● Check current(PWM type) | ● Poor connection of connected part. ● Faulty SIS. ● Faulty SRSCM | |
Enable Conditions | ● Ignition "ON" | ||
Diagnostic Time | Qualification | ● More than 1 sec | |
De-Qualification | ● More than 2 sec | ||
Ignition "OFF", connect scantool.
Ignition "ON"＆ Engine "OFF", select "Diagnostic Trouble Codes(DTC)" mode.
Monitor diagnostic trouble code and present of trouble code.
Using a scantool, clear the DTC.
Is DTC present problem ?
▶ Go to "W/Harness Inspection" procedure.
▶ Displaying nothing(no DTC) or DTC with label "H"(historical) shows that Fault is intermittent caused by poor contact in the part's and/or SRSCM connector or was repaired and SRSCM memory was not cleared.
Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
▶ Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
Many malfunctions in the electrical system are caused by poor harness and terminals.
Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
Has a problem been found?
▶ Repair as necessary and then go to "Verification of Vehicle Repair" procedure.
▶ Go to "Component Inspection" procedure.
Ignition "ON" ＆ Engine "OFF" and Using a scantool, clear the DTC.
Ignition "OFF".
Disconnect the battery (-) terminal cable from the battery, and wait at least one minutes.
Disconnect SIS connector.
Substitute the SIS and check for proper operation.
Is DTC present problem ?
▶ Substitute a known-good SRSCM, and check for proper operation.
If the problem is corrected, replace SRSCM and then go to "Verification of Vehicle Repair" procedure.
▶ Substitute the SRS main harness and check for proper operation.
If the problem is corrected, replace SRS main harness and then go to "Verification of Vehicle Repair" procedure.
▶ Substitute a known-good SIS, and check for proper operation.
If the problem is corrected, replace SIS and then go to "Verification of Vehicle Repair" procedure.
Refer to the DESCRIPTION in this TROUBLESHOOTING section.
