1.
Install the retainer (A) and nuts(B).
Torque : 12-15Nm (1.2-1.5kgf.m, 8.7-10.8Ib-ft)
note
In case, install the crush pad and cowl cross bar. (refer to Crush pad in BD group and Heater unit in HA group)
Install the retainer (A) and nuts(B).
Torque : 12-15Nm (1.2-1.5kgf.m, 8.7-10.8Ib-ft)
In case, install the crush pad and cowl cross bar. (refer to Crush pad in BD group and Heater unit in HA group)
Install the clip (A) connecting the shift cable and the shift lever.
Install the shift lever assembly (A).
Torque : 9~14Nm(0.9~1.4kgf.m, 6.5~10.1Ib-ft)
Insert a U-type pin into the holes shown of the select hinge so that prevent from false shifting when shifting to 1st gear or Reverse.
Move the slide clip (B) of guide member (A) in the direction as shown in the illustration.
Adjust the slide clip fit into the select lever moving the slide clip in the direction.
Install the guide member (A) of the select cable (B).
Adjust the slide clip (B) to fit it into the select lever pin (A) and install the snap pin (C).
Insert the slide clip in the direction as shown in the illustration.
Install the cable assembly placing the select and shift lever in neutral position. (refer to Manual Tramsaxle's installation)
Install the center console. (refer to Console in BD group)
Install the upper cover (A) to the center console.
