REPLACEMENT
caution

After replacing an ECM, MUST input the injector data (7 digit) of each cylinder into a new ECM.

1.

Replace the injector with a new one according to the "REMOVAL" and "INSTALLATION" procedures.

2.

Connect a scan tool to Data Link Connector (DLC) and turn ignition switch on.

3.

Select "ENGINE CONTROL".

4.

Select "AUTO SELECTION MODE" or "MANUAL SELECTION MODE".

5.

Select "1.6L VGT DIESEL" in case of "MANUAL SELECTION MODE".

6.

Select "INJECTOR CORRECTION".

7.

Press "ENTER" key.

8.

Input the injector data (7 digit) written on the top of each inejctor with function keys ([F1] ~ [F6]) and number keys.

note

When "WRITING FAIL" is displayed on the scan tool, input injector data (7 digits) of each cylinder into a new ECM again as prior procedure.

Яндекс.Метрика