3.
Has a problem been found?
YES
a.
Repair as necessary and then go to "Verification of Vehicle Repair" procedure
NO
a.
Go to "Power Circuit Inspection" procedure
Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
Has a problem been found?
YES
Repair as necessary and then go to "Verification of Vehicle Repair" procedure
NO
Go to "Power Circuit Inspection" procedure
Connect "A/T SOLENOID VALVE" connector and install device for measuring wave form
Turn on the Engine and operate Damper clutch
Measure wave form between teminal"4" of the sensor harness connector and chassis ground.
■ Wave form of DCCSV
Is measured normally operating wave form?
YES
Go to "Signal circuit inspection" procedure
NO
Check for open in harness. Repair as necessary and Go to "Verification Vehicle Repair" procedure
Ignition "OFF".
Disconnect "A/T SOLENOID VALVE" connector and "PCM/TCM" connector
Measure resistance between terminal "4" of the ATM SOLENOID VALVE harness connector and terminal "18" of the PCM/TCM harness connector.
Specification: Approx. 0 Ω
Is resistance within specifications?
YES
Go to "Check signal circuit short Inspection" procedure
NO
Check for open in harness. Repair as necessary and Go to "Verification Vehicle Repair" procedure
Ignition "OFF".
Disconnect "A/T SOLENOID VALVE" connector and "PCM/TCM" connector
Measure resistance between terminal "4" of the ATM SOLENOID VALVE harness and chassis ground.
Specification: Infinite
Is resistance within specifications?
YES
Go to "signal circuit ground inspection" procedure
NO
Check for short to ground in harness. Repair as necessary and Go to "Verification Vehicle Repair" procedure
Ignition "OFF".
Disconnect "A/T SOLENOID VALVE" connector and "PCM/TCM" connector
Measure resistance between terminal "7" of the ATM SOLENOID VALVE harness and chassis ground.
Specification: Approx. 0 Ω
Is resistance within specifications
YES
Go to "Component Inspection" procedure
NO
Check for short to ground in harness. Repair as necessary and Go to "Verification Vehicle Repair" procedure
