Component Inspection
■ Check Neutral S/W
1.

IG KEY "OFF".

2.

Disconnect Neutral S/W connector.

3.

Check continuity between Neutral S/W component signal terminal and Ground terminal as shifting gear lever 2~3 times.

Specification : The measured resistance varies from below 1.0Ω(Continuity) to infinite Ω(Discontinuity) in accordance with gear shifting.

4.

Is the measured resistance within the specification?

▶ Many malfunctions in the electrical system are caused by poor harness(es) and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage. So, check poor connections and the related circuit between ECM and component thoroughly. Repair as necessary and go to "Verification of Vehicle Repair" procedure.

▶ Substitute with a known - good Neutral S/W and check for proper operation.

If the problem is corrected, replace Neutral S/W and go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика