6522379

1.

Electrical systems consist of a lot of harness and connectors, poor connection of terminals can cause various problems and damge of component.

2.

Perform checking procedure as follows.

(1)

Check damage of harness and terminals : Check terminals for contact resistance, corrosion and deformation.

(2)

Check connecting condition of ECM and component connector : Check terminal seperation, damage of locking device and connecting condition between terminal and wiring.

note

Disconnect the pin which requires checking at male connector and insert it to the terminal at female connector for checking connecting condition. ( after checking, reconnect the pin at correct position. )

3.

Is the problem found?

	▶ Repair the trouble causing part and go to "Verification of Vehicle Repair".
	▶ Go to "Power Circuit Inspection".

1.

IG KEY "OFF", ENGINE "OFF"

2.

Disconnect DPS connector.

3.

IG KEY "ON"

4.

Measure the voltage between power supply terminal of DPS harness connector and chassis ground.

Specification : 4.8V~5.1V

5.

Is the measured voltage within the specification?

	▶ Go to "Signal Circuit Inspection".
	▶ Repair open in power circuit and go to "Verification of Vehicle Repair".

1.

IG KEY "OFF", ENGINE "OFF"

2.

Disconnect DPS connector.

3.

IG KEY "ON"

4.

Measure the voltage between signal terminal of DPS harness connector and chassis ground.

Specification : 4.8V~5.1V

5.

Is the measured voltage within the specification?

	▶ Go to "Component Inspection".
	▶ Repair short to ground in signal circuit and go to "Verification of Vehicle Repair".