6524594

Terminal and Connector Inspection

Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.

Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

Has a problem been found?

	▶ Repair as necessary and go to "Verification vehicle Repair" procedure.
	▶ Go to "Power circuit inspection" procedure.

Power Circuit Inspection

Disconnect "TRANSAXLE RANGE SWITCH" connector.

Ignition "ON" & Engine "OFF".

Measure voltage between each teminal of the sensor harness connector and chassis ground.

Specification :

TERMINAL	1	2	3	5	6	7	8	9	10
SPECIFICSTION	0V	0V	0V	0V	0V	0V	12V	0V	0V

note

To view Flash content, you need to install the appropriate browser extension

note

To view Flash content, you need to install the appropriate browser extension

Is voltage within specifications?

	▶ Go to "Signal circuit inspection" procedure.
	▶ Check for Short in harness. Repair as necessary and Go to "Verification Vehicle Repair" procedure.

Signal Circuit Inspection

Ignition "OFF".

Disconnect "TRANSAXLE RANGE SWITCH" and "TCM(PCM)" connector.

Measure resistance between each teminals of the sensor harness to check for Short.

Specification : Infinite

note

To view Flash content, you need to install the appropriate browser extension

note

To view Flash content, you need to install the appropriate browser extension

Is resistance within specifications?

	▶ Go to "Component inspection" procedure.
	▶ Check for Short in harness. Repair as necessary and Go to "Verification Vehicle Repair" procedure.