4.
Shift gear at each position .
Fig 1) "P,N"
Fig 2) "R"
Fig 3) "1st" grar
Fig 4) "2nd" gear
Fig 5) "3rd" gear
Fig 6) "4th" gear
Connect scantool to data link connector(DLC)
Engine "ON" .
Monitor the "PCSV-B(2-4SOLENOID VALVE)" parameter on the scantool
Shift gear at each position .
Fig 1) "P,N"
Fig 2) "R"
Fig 3) "1st" grar
Fig 4) "2nd" gear
Fig 5) "3rd" gear
Fig 6) "4th" gear
Does "PCSV-B(2-4SOLENOID VALVE)" follow the referance data?
 | ▶ Fault is intermittent caused by poor contact in the sensor's and/or PCM/TCM's connector or was repaired and PCM/TCM memory was not cleared. Throughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage.Repair or replace as necessary and go to "Verification Vehicle Repair" procedure . |
 | ▶ Go to "W/Harness Inspection " procedure. |
