Component Inspection
■ CHECK SOLENOID VELVE
1.

Ignition "OFF".

2.

Disconnect "A/T SOLENOID VALVE" connector.

3.

Measure resistance between terminal "3" and terminal "7" of the ATM SOLENOID VALVE harness connector.

Specification : Approximately 3.5 ± 0.2 Ω (25℃)

4.

Is resistance within specifications?

▶ Go to "CHECK PCM/TCM " as below.

▶ Replace ON/OFF SOLENOID VALVE as necessary and go to "Verification Vehicle Repair" procedure.

■ CHECK PCM/PCM/TCM
5.

Connect scantool to data link connector(DLC)

6.

Ignition "ON" & Engine "OFF".

7.

Select A/T Solenoide valve Actuator test and Operate Actuator test.

8.

Is Actuator Testing performed normally ?

▶ Go to "Verification Vehicle Repair" procedure.

▶ Replace PCM/TCM as necessary and Go to "Verificaiton Vehicle Repair" procedure.

ACTUATOR TEST CONDITION

1)

IG SWITCH ON

2)

TRANSAXLE RANGE SWITCH is normal

3)

P RANGE

4)

Vehicle Speed 0km/h

5)

Throttle position sensor < 1V

6)

IDLE SWITCH ON

7)

ENGINE RPM 0

Яндекс.Метрика