3.
Measure resistance between terminal "4" and terminal "7" of the ATM SOLENOID VALVE harness connector.
Specification : Approximately 3.5 ± 0.2 Ω (25℃)
Ignition "OFF".
Disconnect "A/T SOLENOID VALVE" connector.
Measure resistance between terminal "4" and terminal "7" of the ATM SOLENOID VALVE harness connector.
Specification : Approximately 3.5 ± 0.2 Ω (25℃)
Is resistance within specifications?
 | ▶ Go to "CHECK PCM/TCM " as below. |
 | ▶ Replace DCC SOLENOID VALVE as necessary and go to "Verification Vehicle Repair" procedure. |
Connect scantool to data link connector(DLC)
Ignition "ON" & Engine "OFF".
Select A/T Solenoide valve Actuator test and Operate Actuator test.
Is Actuator Testing performed normally ?
| ▶ Go to "Verification Vehicle Repair" procedure. |
| ▶ Replace PCM/TCM as necessary and Go to "Verificaiton Vehicle Repair" procedure. |
ACTUATOR TEST CONDITION
IG SWITCH ON
TRANSAXLE RANGE SWITCH is normal
P RANGE
Vehicle Speed 0km/h
Throttle position sensor < 1V
IDLE SWITCH ON
ENGINE RPM 0
