4.
Driving at speed of over 30 km/h.
Specification : Increasing Gradually
Fig 1) "P,N" Range
Fig 2) "R" Range,Vehicle Speed = 0
Fig 3) "D" Range,Vehicle Speed = 0
Fig 4) High Speed Driving
Connect scantool to data link connector(DLC)
Engine "ON" .
Monitor the "INPUT SPEED SENSOR" parameter on the scantool.
Driving at speed of over 30 km/h.
Specification : Increasing Gradually
Fig 1) "P,N" Range
Fig 2) "R" Range,Vehicle Speed = 0
Fig 3) "D" Range,Vehicle Speed = 0
Fig 4) High Speed Driving
Does "Input Speed Sensor " follow the referance data?
 | ▶ Fault is intermittent caused by poor contact in the sensor's and/or TCM(PCM)'s connector or was repaired and TCM(PCM) memory was not cleared. Throughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage.Repair or replace as necessary and go to "Verification Vehicle Repair" procedure. |
 | ▶ Go to "W/Harness Inspection" procedure. |
