3.
Monitor the "TRANSAXLE FLUID TEMPERATURE SENSOR" parameter on the scantool
Specification : Increasing Gradually
Fig 1) Normal
Fig 2) Signal harness Open
Fig 3) Signal harness Short
Connect scantool to data link connector(DLC)
Engine "ON" .
Monitor the "TRANSAXLE FLUID TEMPERATURE SENSOR" parameter on the scantool
Specification : Increasing Gradually
Fig 1) Normal
Fig 2) Signal harness Open
Fig 3) Signal harness Short
Does "TRANSAXLE FLUID TEMPERATURE SENSOR " follow the referance data?
 | ▶ Fault is intermittent caused by poor contact in the sensor's and/or TCM(PCM)'s connector or was repaired and TCM(PCM) memory was not cleared. Throughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage.Repair or replace as necessary and go to "Verification Vehicle Repair" procedure. |
 | ▶ Go to "W/Harness Inspection" procedure. |
※ Most of fault that happen about inhibitor switch, result from faulty shift cable adjustment or incorrect location of manual control lever and inhibitor switch. So, when DTC which related Inhibitor switch or engine start defectiveness at "P" range happen, After check the shift cable adjustment or location of manual control lever and inhibitor switch, repair or replace as necessary.
