Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.

Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

Has a problem been found?

	▶ Repair as necessary and go to "Verification vehicle Repair" procedure
	▶ Go to "Signal circuit inspection" procedure

Ignition "ON" & Engine "OFF".

Disconnect the "TRANSAXLE FLUID TEMPERATURE SENSOR" connector.

Measure the voltage between terminal "5" of the "TRANSAXLE FLUID TEMPERATURE SENSOR" harness connector and chassis ground.

Is voltage within specifications ?

	▶ Go to "Ground circuit inspection" procedure.
	▶ Check for open in harness. Repair as necessary and Go to "Verification Vehicle Repair" procedure.

Ignition "OFF".

Disconnect the "TRANSAXLE FLUID TEMPERATURE SENSOR" connector.

Measure the resistance between terminal "6" of the "TRANSAXLE FLUID TEMPERATURE SENSOR" harness connector and chassis ground.

Is resistance within specifications ?

	▶ Go to "Component inspection" procedure.
	▶ Check for open in harness. Repair as necessary and Go to "Verification Vehicle Repair" procedure.