3.
Measure resistance between terminal "1" and "2" of SMARTRA.
1)
Specification : Approx 8.5 Ω
Ignition "OFF"
Disconnect SMARTRA connector
Measure resistance between terminal "1" and "2" of SMARTRA.
Specification : Approx 8.5 Ω
Is the measured resistance within specifications?
YES
Go to "Check SMARTRA" procedure
NO
Check for open or short in antenna coil. Repair as necessary and go to "Verification of Vehicle Repair" procedure.
IGN "ON" & Engine "OFF"
Neutralize ECM and Register transponder key by scantool.
※ Pin code is requied to Neutralize ECM and to Register transponder key
Are Neutralizing and Registering completed normally ?
YES
Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
NO
Substitute with a known-good SMARTRA and check for proper operation.
If the problem is corrected, replace SMARTRA and then go to "Verification of Vehicle Repair" procedure.
