3.
Has a problem been found?
YES
a.
Repair as necessary and go to "Verification Vehicle Repair" procedure.
NO
a.
Go to "W/Harness Inspection" procedure.
Many malfunctions in the electrical system are caused by poor harness and terminals.
Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
Has a problem been found?
YES
Repair as necessary and go to "Verification Vehicle Repair" procedure.
NO
Go to "W/Harness Inspection" procedure.
Ignition "OFF".
Disconnect AQS sensor.
Measure resistance between terminal "3" of AQS sensor and terminal "2" of A/C Control Unit.
Specification :Approx. 0 Ω
Is the measured resistance within specifications?
YES
Go to "Ground circuit Inspection " procedure.
NO
Check for open in harness. Repair as necessary and go to "Verification of Vehicle Repair" procedure.
Ignition "OFF".
Disconnect AQS sensor.
Measure resistance between terminal "2" of AQS sensor and chassis ground.
Specification :Approx. 0 Ω
Is the measured resistance within specifications?
YES
Go to "Power circuit Inspection " procedure.
NO
Check for open in ground harness. Repair as necessary and go to "Verification of Vehicle Repair" procedure.
Ignition "OFF".
Disconnect AQS sensor.
Measure voltage between terminal "1" of AQS sensor and chassis ground.
Specification : 9~16V
Is the measured resistance within specifications?
YES
Go to "Component Inspection " procedure.
NO
Check for open or short in ground harness. Repair as necessary and go to "Verification of Vehicle Repair" procedure.
